Samsung RS2530B - 4-6) Load Status Display

31
1) When pressing “ICE TYPE” and “FILTER RESET(LIGHT)” KEYS simultaneously for 6 sec. in normal
operation, the indicators of temp set in Freezer/Refrigerator will all ON/OFF for 2 sec. at the interval of 0.5 sec.
At this point, when pressing Temp Set Key in Refrigerator while canceling “ICE TYPE” and “FILTER
RESET(LIGHT)” KEYS, it operates load status display.
2) Load status display will show the load in operation REAL TIME.
However, it is not related to real status of operation of load and it only shows the directed status of the load
operation command from MICOM.
3) Only corresponding ICON for the load in operation will be ON/OFF repeatedly and turned off.
4) Load status display will continue for 30 sec. and it will restore to the normal state.
ALIGNMENT AND ADJUSTMENTS
4-6) LOAD STATUS DISPLAY
② Press after ①
NO ITEMS DISPLAY LED PROBLEM
01
02
03
04
05
06
07
08
09
Damper
Condition for
over load
Condition for
low temp
COMP
Freezer Defrost
Heater
Freezer FAN
Exhibition Mode
Dispenser Heater
Damper Heater
Refrigerator "MIN" (1’st)
Refrigerator "MID" (3’rd)
Refrigerator "MAX" (5’th)
Freezer "MIN" (1’st)
Freezer "MID" (3’rd)
Freezer "MAX" (5’th)
ICE OFF
CUBE LED
CRUSH LED
LED ON whenDamper is open
LED ON when Ambient temp is over (95°F/35 °C)
LED ON when ambient temp is lower than (62.6 °F/17 °C)
Relevant LED ON whenCOMP operates
LED ON when Freezer Defrost Heater operates
Relevant LED ON when Freezer-FAN HIGH operates
LED ON in Display mode
Relevant LED ON when Dispenser Heater gets ON
Relevant LED ON when Damper Heater gets ON
󳢬 Details by LED ON locations indicating load status
① Press for 6 seconds