38
DISASSEMBLY & REASSEMBLY
3-16) Machine Compartment
Unscrew the 6 screws of the
Compressor Cover.
① Remove the 2 Drain-Tubes.
② Disengage the housing
connector(Fan Motor).
(Refer to the picture)
① Take off the Seal carefully for reuse.
② Disassemble the hook of the Support
Circuit Motor Assy by lifting up.
① Remove the spring with a plier.
② Disassemble the Fan by pulling it out
while grasping the Motor part.
Unscrew the 2 screws and disassemble
the Motor.
Tilt the Fan Motor Assy and pull it out as
shown in the picture.
PART NAME DESCRIPTION
Motor Fan
FIGURE
To Next Page
Loading...
