Samsung RVXVHT080 series - Symptom-Based Fault Diagnosis (DVM HR2 Series)

Samsung Electronics9-69
■
: Communication error between the outdoor unit and MCU
Outdoor unit display
Indoor unit display
Judgment method
Causes - Communication error between the outdoor unit and MCU
9-5 Fault Diagnosis by Symptom(DVM HR2 Series)
No
No
Yes
Yes
Yes
Yes
Yes
Is OK the connection between
the outdoor unit and communication
connector?
Press the reset(K3) outdoor unit PCB
and check the display part.
Is there any response of MCU or
indoor unit from the display part on tracking?
MCU address: Fb-FE
Is the voltage of
2 lines square wave of
DC ±0.7V?
If there is no error after checking the
communication line and connector of out-
door PCB, replace MCU PCB.
If there is no error after checking the
communication line, replace MCU PCB.
Check again the communication line con-
nected with MCU.
Restart after connecting a
connector to PCB.
Remove the communication line from the out-
door unit to MCU, and measure 2 lines of
indoor unit side by use of scope.
After connecting the communication line connected
from the outdoor unit to MCU again, remove all commu-
nication connectors of MCU and outdoor unit. And then
connect it one by one to find a communication obstacle
and replace PCB after checking the communication line.
No