- 8 -
S43DM70*
x 4x 3
1
1
2
As shown in the figure, remove the product and foam cushion, and then place the
product on the table with its front side facing the floor.
Put the stand base onto the stand neck
as the direction shown in the figure.
Check that the stand neck is firmly
connected.
3
4
Place the stand on a table as shown in the figure. With the
stand neck fastened vertically to the stand base, tightly
fasten the connecting screws at the bottom of the stand
base.
Push the assembled stand into the main body in the
direction of the arrow as shown in the figure. Tightly fasten
the connecting screw at the bottom of the main body.
4
5
4
6
Stand up the monitor as shown in the
figure.
● Hold the lower corners or edges
of the product when moving it.
● Do not directly apply pressure on
the screen.
● Do not hold the screen when
moving the product.
● Do not hold the product upside
down only by the stand.
Stand assembly is complete.
Caution
Do not arbitrarily remove the panel
film. If not observed, the warranty
service may be restricted.
To Next Page
Loading...
