• SW Version Information
Check the currently installed software version, and update the software to the latest version, if necessary.
• Wireless One Connect Test
Check the Wireless One Connect Test power supply and connection, and check that it operates properly.
• Picture Test
Use test photos to check for problems with the screen.
• Remote Control
Check for problems with the Remote Control connection or buttons.
• Wi-Fi
Check whether the Wi-Fi module is working normally. The result may appear to be a failure if there is no
available access point (AP) in the vicinity.
• IoT Module
Check whether the IoT Module is working normally.
• Light sensor
Check whether the light intensity sensor is working normally.
• Broadcast Signal
Check the condition of the current broadcast signal.
Cannot select Broadcast Signal in Self Diagnosis.
Verify that the current channel is a digital channel.
Broadcast Signal is only available for digital channels.
•
left directional button Settings Support Device Care Self Diagnosis Broadcast Signal
This function may not be supported depending on the model or geographical area.
- 257 -
To Next Page
Loading...
