53
Use WPS
How to set up using Use WPS
If your router has a Use WPS button, follow these steps.
1
Set Network Type to Wireless from the Open Network Settings page.
2
Select Use WPS, press E.
3
Press the WPS or PBC button on your wireless router withine the next two minutes. Your
product automatically acquires all the network setting values it needs and connects to your
network.
– If you want to use the WPS PIN, select WPS PIN.
Go to your wireless router's Settings, enter your PIN, and then select OK.
4
The network connection screen appears, and network setup is done.
IPv6
m MENUNetworkIPv6E
Enable or disable IPv6.
Off ( ) / On ( )
IPv6 Status
m MENUNetworkIPv6 StatusE
Check the status of your IPv6 Internet connection.
To Next Page
