24 – High Resolution Compact ATM Camera
How to use OSD Menu
ELC
LEVEL [00]----I----
BACKLIGHT BLC
AREA USER
<SIZE>
<LOCATION>
③
If you set the BACKLIGHT option to WDR, you will
see a menu where you can set the WDR options.
Specify the composition level in the WEIGHT menu.
You can also select any of OUTDOOR, and
INDOOR in WHITE BAL.
For ANTI ROLLING, select an option to reduce
the COLOR ROLLING effect.
ELC
LEVEL [ 00]----I----
BACKLIGHT WDR
WEIGHT MID
WHITE BAL INDOOR
ANTI ROLLING MID
WDR(Wide Dynamic Range) extends the gain
range of the screen that is mostly useful if you
take a simultaneous picture of both indoor and
outside of the window.
Namely, it improves the sharpness of the picture
in outdoor scenery as well as indoor.
Note :
If you use the VPS (Virtual Progressive Scan) function, the CCD
reads differently so you can not use WDR simultaneously.
If you set VPS to ON, WDR will be automatically set to OFF.
For SCB-2020, the WDR mode is not available.
AGC
[OFF, VERY LOW, LOW, MID, HIGH, VERY
HIGH, USER, FIX]
The AGC (Auto Gain Control) menu is used to
set the AGC level of the camera. When the AGC
is active, the camera automatically increases the
sensitivity by amplifying the Video signal when the
strength of the signal falls below the normal value.
If OFF or FIX mode is selected in the SENS-UP
menu, you can specify the AGC level.
If you press the SETUP switch with a USER sub
menu selected, you will see the appropriate screen.
AGC USER
LEVEL [16]
In USER mode, you can break down the level in
16 steps from VERY LOW to VERY HIGH to your
preference.
–
–
❖
To Next Page
Loading...
