26 – High Resolution Compact ATM Camera
How to use OSD Menu
XDR (eXtended Dynamic Range)
[OFF, LOW, MID, HIGH]
Actively controls the gamma compensation in the
way it operates the ambient luminance contrast in a
certain pixel unit to determine the optimal visibility.
Select one from OFF, LOW, MID and HIGH. Closing
to HIGH will increase the compensation level.
DAY/NIGHT
[DAY,NIGHT,AUTO]
DAY
If set to DAY, it will be fi xed to DAY mode regardless
of the ambient conditions.
NIGHT
If set to NIGHT, it will be fi xed to Black-and-White
mode regardless of the ambient conditions.
If you press the SETUP switch with a NIGHT sub
menu selected, you will see a menu where you can set
Burst to OFF/ON.
If BURST is set to ON, the Burst signal will output
together with the black-and-white composite video
signal. If BURST is set to OFF, the Burst signal does
not output.
You can set the BURST option to OFF/ON, or select
to output the Burst signal in NIGHT mode.
AUTO
The camera will automatically switch between DAY
and NIGHT mode, according to the lighting condition.
If you press the SETUP switch with an AUTO-based
sub menu selected, you will see the appropriate
screen.
❖
❖
•
•
•
AUTO
BURST OFF
DAYÆNIGHT
BRIGHTNESS MID
DWELL TIME 2SEC
NIGHTÆDAY
BRIGHTNESS MID
DWELL TIME 5SEC
MASK AREA 1 2
You can set the BURST option to OFF/ON, or
select to output the Burst signal in NIGHT mode.
Brightness of DAYÆNIGHT sets the criterion for
switching color (C) to black&white (BW), selectable
from LOW, MEDIUM and HIGH. The lower the
setting (HIGH Æ LOW) is, the darker condition the
switching will be.
The DWELL TIME of DAYÆNIGHT is the criterion
of switching requirement.
Brightness of NIGHT Æ DAY sets the criterion for
switching black&white (BW) to color (C), selectable
from LOW, MEDIUM and HIGH. The lower the
setting (HIGH Æ LOW) is, the darker condition the
switching will be.
The DWELL TIME of NIGHT Æ DAY is the
criterion of switching requirement.
The MASK AREA menu is provided for preventing
switching failure or error which may be caused by
bright spot lighting source at night.
The MASK menu is used to prevent a fi lter switch
error or inability of determining the switch in
existence of a high spot light source at night.
To Next Page
Loading...
