User GuideUser Guide
■
Function Switch
Function switch located at the rear side of the camera within the dome
cover. Sets the White Balance mode.
■
ATW (Auto Tracing White Balance
Automatically adjusts the color temperature of the screen (within 2500-
9500 color temperature range) according to the temperature change in
external environments.
■
AWC (Auto White Balance Control)
Adjusts the color temperature to the color temperature stored when
switched to AWC.
4 5
3. Function of Each Component
■
Fixed focus lens
• Fixed focus lens installed on the camera.
Please take cautions that any dust or foreign matter gathers on the
front glass surface of the lens.
■
Main body
• A body that supports the camera.
■
PCB board
• This part is quite important since it performs the camera function.
Please handle with care.
■
Power cable
• The terminal that is connected to the power (adaptor) cable.
Connect to DC 12V.
■
Video signal output cable
• The cable that sends the video signal.
■
Dome cover
• The transparent plastic cover that protects the camera.
Be careful not to make a scratch on it.
E
To Next Page
Loading...
