Call Functions 31
Answering a Call
Dialing a Number
To dial a number using Voice Dial, do the following:
1. In standby mode, press and hold the key.
“Say a Command” appears in the display and is pronounced through the
speaker.
2. Say “Call”.
VoiceSignal prompts you to “Say the name or #.”
3. Speak clearly and say the telephone number of the person you want to call.
For example, say “7 8 1 9 7 0 5 2 0 0."
If it recognizes the number, Voice Dial repeats it and dials the number. If
Voice Dial is not sure it has recognized the number, it displays a choice list
of up to three numbers and prompts you with “Did you say?” followed by
the first number on the list.
4. Say “Yes” to confirm the number or “No” to hear the next one, or use the
keypad to select the correct number from the list. (See See “Choice Lists”
on page 97, for more information.)
• Press the Repeat (right) soft key ( ) to say the name again.
• Press the Settings (left) soft key ( ), then press the Exit (right) soft key ( )
to exit VoiceSignal without dialing.
Pause Dialing From a Contacts Entry
•
If you voice dial a contact that contains 2-Sec Pause(s) simply wait for the pauses
to pass and the dialing to complete.
• If you voice dial a contact that contains Wait(s), wait for the appropriate prompt(s)
from the number you are calling (credit card number, bank account number, and
so on) and enter the appropriate response(s).
Answering a Call
Incoming
When you receive a call, the phone displays one of the following:
• If the caller can be identified, the caller’s number (or name if it’s in your Contacts)
appears in the display.
• If the caller cannot be identified, Call from unavailable #, Call from restricted #,
or no number appears in the display.
To Next Page
Loading...
