54
Open Contacts
1. In standby mode, press the Menu key ( ), then press for Contacts.
The following options appear in the display:
•Find — Find a phone number By Name.
Tip: You can also access the Find option from standby mode, by pressing the Contacts (right) soft key
().
• Add New Entry — Add a number or e-mail address to your Contacts.
•Speed Dial — Assign a Contacts entry to a Speed Dial number. (See “Speed
Dial” on page 63 for more information.)
•Group — Review, send messages to, add Contacts to, or rename four out of
your five groups. (See “Contacts Groups” on page 65 for more information.)
• Memory Info — Display used and available memory for Contacts entries.
Tip: To launch the Contacts menu using a voice command — In standby mode, press and hold until
the phone prompts, “Say a command.” Say “Go to Contacts” into the microphone.
2. Use the navigation keys to highlight the option of your choice, and press
the key.
Tip: You can also press the keypad number key that corresponds to the menu option number.
Finding a Contacts Entry
Voice Method
Use the VoiceSignal Lookup command to view contact information for any named
contact stored in your Contacts list by saying the name.
Note: The Lookup command shows the requested contact information in the display but does not dial any
phone numbers for the contact.
To look up information for a specific contact:
1. In standby mode, press and hold the key to launch VoiceSignal.
“Say a Command” appears in the display and is pronounced through the
speaker.
2. Say “Lookup”.
VoiceSignal prompts you to “Say the name.”
To Next Page
Loading...
