Samsung SCL300 - Page 54

Samsung Electronics 5-33
Alignment and Adjustment
2-2. Head Switching Point
: This adjustment is performed after the
replacement of deck mechanism.
¥ Without this adjustment, there will be a noise
in playback picture.
a. Preparations
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE(MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 0A.
e. Insert the Standard Color Bar Tape and press
the PLAY button.
Note : If there is no video out, when you pressed
the PLAY button, you can not adjust the
Head Switching Point.
It may be caused by maladjusted VIDEO
block.
In this case, adjust the VIDEO block before
the Head Switching Point.
VIDEO block adjustments are 2-3~2-11.
f. The data of Head Switch is set to 6.2H~6.7H
automatically.
g. Be sure to press the ÒMENU/ENTER(CON-
FIRM)Ó button of CAMCORDER to memorize
setting.
h. Reset the power source so as to fix the new data
to the camcorderÕs EEPROM.
2. Adjustment
* Please keep the order according to explanation.
2-1. Setting of the model name
a. Preparation
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE(MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 19.
e. Press the ÒEDIT + (DATA UP)/EDIT Ð (DATA
DOWN)Ó so that OSD shows ÓERR:XX EVR:
XXÓ ÒXXÓ is different dependent on the model
as below.
f. Be sure to press the ÒMENU/ENTER(CON-
FIRM)Ó button of CAMCORDER to memorize
setting.
g. Reset the power source so as to fix the new data
to the camcorderÕs EEPROM.
TAPE
STANDARD COLOR BAR TAPE
RECORDED WITH SP SPEED
DC POWER SUPPLY
0A
HD SWP
EQUIPMENT
OTHER
TEST POINT
ADDRESS
NAME
0A.HD SW P
EPR : XX EVR : YY
6.5H
MODEL NAME MODEL NAMEADDRESSED CODE ADDRESSED CODE
30 30
3240
3332
3533
9835
80
85
SCL300 VP-L300
VP-L320SCL310
VP-L330SCL320
VP-L350SCL330
VP-L980SCL350
SCL800
SCL850
TAPE NONE
DC POWER SUPPLY
NONE
NONE
19
MODEL CODE
EQUIPMENT
OTHER
TEST POINT
ADDRESS
NAME