2-4. Adjusting Y-Emphasis Input
: This adjustment is performed to set the Y level
which is recorded in tape.
Maladjusted Y level impact to the next adjust-
ment.
a. Preparations
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE (MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 02.
e. Insert a Normal Tape to the camcorder.
f. Connect the oscilloscope to the addressed Test
Point.
g. Press the ÒEDIT + (DATA UP)/EDIT Ð (DATA
DOWN)Ó button so that the IC201 PIN13 is
0.5±0.02Vp-p from SYNC tip to peak level.
h. Be sure to press the ÒMENU/ENTER(CON-
FIRM)Ó button of CAMCORDER to memorize
setting.
i. Reset the power source so as to fix the new data
to the EEPROM.
Samsung Electronics5-34
Alignment and Adjustment
2-3. Adjusting Color Bar Level
: This adjustment is performed to set the stan-
dard level of color bar signal which is generat-
ed internally.
a. Preparations
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the ÒTITLE (MODE UP)/DATE/TIME
(MODE DOWN)Ó button of CAMCORDER so
as to select the address 1C.
e. Connect the oscilloscope to the addressed Test
Point.
f. Press the ÒEDIT + (DATA UP)/EDIT Ð (DATA
DOWN)Ó button so as to set the P-P level of
composite to 0.5V±0.02Vp-p.
Note : The level is changed after the confirmation.
g. Be sure to press the ÒMENU/ENTER(CON-
FIRM)Ó button of CAMCORDER to memorize
setting.
h. Reset the power source so as to fix the new data
to the EEPROM.
DC POWER SUPPLY, OSCILLOSCOPE
IC 201 PIN 13
02
Y-EMPHASIS IN (NOR)
EQUIPMENT
OTHER
TEST POINT
ADDRESS
NAME
8MM (NORMAL) TAPE
To Next Page
Loading...
