hen
SYNC
: In areas where the supply is at
60Hz(NTSC), 50Hz(PAL) frequency,
you can synchronize the output
phase of multiple cameras using
the power synchronization function
(Line-Lock) without using a
synchronization signal generator.
INT : Internal Synchronization Type
L/L : Power Synchronization Type, Line-lock
➊
Set up the mode using the Function Setup switch.
➋
You can select a desired phase from 0 to 359 when select 'phase'.
When using AC power at 60Hz(NTSC), 50Hz(PAL) frequency, you can use the L/L type
synchronization.
When the power is DC 12V, the SYNC menu is fi xed to the ‘INT’ mode.
MOTION DET
:
Allows effective monitoring by displaying
“MOTION DET” message on the screen
whenever a motion is detected, for all 8
monitored split screens.
➊
When the SPECIAL menu
screen is displayed, press
the Function Setup switch so
that the arrow indicates‘MOTION
DET’.
➋
Set up the mode using the Function Setup switch.
SENSITIVITY : You can select up to 8 MD areas. When SENSITIVITY
number is high, motion detection sensitivity is increased to
recognize even small movement.
AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
SEL POS :
Determines which of the 4 vertices of each MD area is to be used.
XPOS : Determines the coordinate of the horizontal axis for SEL POS.
YPOS : Determines the coordinate of the vertical axis for SEL POS.
FILL
→
SET :
Fills in a selected MD area. The color of fi lling is sequentially selected
as brown, orange, blue, cyan, green, yellow, magenta and red.
RETURN : Select this to save the MOTION DET menu settings and return
to the SPECIAL menu.
y
-
-
y
-
-
-
-
-
-
-
MOTION DET
䯝 1.SENSITIVITY AREA1
2.AREA MODE ON
3.SEL POS L-TOP
4.XPOS
Â
IIIIIIIIIIIIIIIIIIIII
3
5.YPOS
III
Â
IIIIIIIIIIIIIIIIII
5
6.FILL → SET
7.RETURN
SYNC
䯝 PHASE
IIIIII
Â
IIIIIIIIIIIIIII
0
Press SET to Return
To Next Page
Loading...