Service Manual
Precautions
5-18
Samsung Electronics
5.12 Fuser Ass'y
1. Before you remove the Fuser Ass'y, you should
remove:
- Rear Cover (see page 5-2)
2. Unplug the two connectors from the Main PBA and
SMPS, as shown below. Then remove the 4 screws
securing the Fuser Ass'y and remove it.
3. Remove the 2 bolts securing the Thermostat. Then lift
the Thermostat out taking care not to loose the 2 nuts.
4. Remove the 2 screws securing the Halogen Lamp.
Then take out the Halogen Lamp from the Heat Roller
5. Remove 4 screws to remove the fuser cover as
below. Remove 2 screws to remove the guide input.
To Next Page
Loading...
