Samsung series 4 4000 - Plug & Play (Initial Setup); If You Want to Reset Plug & Play...


Plug & Play (Initial Setup)
When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings. To turn on
the TV, press the POWER
# button.
✎ Plug & Play is available only when the Source is set to TV.
✎ To return to the previous step in the Plug & Play sequence, press the red button on your remote.
1
Selecting the OSD
Language
Press the  or  button, and then press the  or button to select
a language. Press
ENTER
 when done.
2
Selecting the usage
mode
Press the  or  button to select, and then press the ENTER

button.
y Select the Home Use mode. Store Demo mode is for retail
environments.
3
Setting the Clock
Mode
Press the  or  button. Press the  or  button to select Auto or Manual, and then
press
ENTER  .
✎ If you selected Auto, you’ll select the time zone where you live next, and then select
whether to turn DST (Daylight Savings Time) On or Off.
✎ If you selected Manual, you’ll use the number buttons or  or  button to set the
date and time. Use the  or  button to move between entry fields.
4
Selecting search
options for auto tuning
Press the  or  button to select Air or Cable, and then press ENTER
 . A check
appears on your selection. Select Next, and then press the ENTER  button. You can
check both if you have both connected.
✎ If you selected Cable, you’ll go to the Cable System screen. Use the  or  button
to select Digital or Analog, and then press ENTER  . Use the  or  button to select
the correct cable signal format - STD, HRC, or IRC - and then press ENTER  .
Most cable systems use STD. Select the correct cable signal format for both the
Digital and Analog systems. When done, select Search, and the press ENTER  .
5
Selecting and
memorizing channels
The channel search will start automatically. This can take up to 30 minutes.
For more information, refer to Channel  Auto Program in the e-Manual.
✎ Press the ENTER  button at any time to interrupt the memorization process.
6
Enjoy your TV.
Press the ENTER
 button.
If You Want to Reset Plug & Play...
 MENU 3  System  Plug & Play  ENTER 
✎ To change the TV’s settings from Store Demo to Home Use when not in Plug &Play, press the volume button on the
TV. When you see the volume in the OSD, press and hold MENU for 5 sec.
P
POWER