Why is no number dialled when I recall a contact card on my Samsung SGH-i320 Cell Phone?
If no number is dialled when you recall a contact card on your Samsung Cell Phone, check that a number has been stored in the contact card. If necessary, re-store the number.
What to do if 'PIN code' appears on my Samsung Cell Phone?
If “PIN code” appears on your Samsung Cell Phone, it could be because you are using the phone for the first time and must enter the Personal Identification Number (PIN) supplied with the SIM card. Alternatively, the PIN check feature may be enabled. To disable this feature, press the Start soft key and select Settings ? More... ? Security ? Disable SIM PIN, and enter the PIN.
Why do the signal bars disappear on my Samsung Cell Phone?
If the signal bars disappear on your Samsung Cell Phone, wait about 2 minutes after turning on your phone to allow it to find the network. If you are in a tunnel or elevator, the phone may not receive the network signal properly; move to an open place. This can also occur when moving between different service areas, which is normal.
Why is my Samsung SGH-i320 not dialling the number I entered?
If your Samsung Cell Phone is not dialling the number you entered, ensure that you have pressed . Also, check if your wireless connection to your mobile service provider is switched on and the network signal is unobstructed. You may also have set an outgoing call barring option.
Why can't I find my friend's Bluetooth device on my Samsung Cell Phone?
If you cannot find your friend’s Bluetooth-enabled device using your Samsung Cell Phone, check that both devices have activated Bluetooth, that the distance between the two devices is not over 10 metres, and that there are no walls or other obstructions between the devices. Also, ensure that the other device is not in Hidden mode and that both devices are compatible.
Why can't I select a contact card when creating a message on my Samsung SGH-i320?
If you cannot select a contact card when creating a message on your Samsung Cell Phone, it may be because the contact card does not have a phone number or e-mail address. Add the missing information to the contact card in Contacts.
What to do if 'PUK Required' appears on my Samsung SGH-i320 Cell Phone?
If “PUK Required” appears on your Samsung Cell Phone, it means the PIN code was entered incorrectly three times, blocking the SIM card. Enter the PUK supplied by your service provider.
Why does the LED blink while charging my Samsung SGH-i320?
If the LED on the travel charger blinks while charging your Samsung Cell Phone, disconnect the phone from the charger, remove the battery, and then replace it. Try charging again. If the problem persists, clean the metal contacts on the battery and the phone.
What to do if my Samsung SGH-i320 malfunctions?
If your Samsung Cell Phone malfunctions or does not function, try removing the battery and then replacing it, then turn on the phone. Alternatively, press the hole on the bottom of the phone to perform a soft reset.
Why is the standby time shorter than expected on my Samsung SGH-i320 Cell Phone?
The standby time on your Samsung Cell Phone might be shorter than expected because batteries degrade over time. Leaving a fully charged battery in a cold or hot place for a long time can also reduce its life. Also, standby time depends on where you use the phone, and the actual time may differ from the battery’s specifications.
General| Brand | Samsung |
|---|---|
| Model | SGH-i320 |
| Category | Cell Phone |
| Language | English |
To Next Page
