What to do if my Samsung SGH-I300 Cell Phone won't turn on even with sufficient battery?
Try removing the battery from the phone and reinstalling it. Then turn on the phone. If that doesn't work, clean the metal contacts both on the battery and on the phone, reinstall the battery, and try turning on the phone again.
What to do if my Samsung SGH-I300 says 'No network coverage'?
If your Samsung Cell Phone displays “No network coverage,” “Error unable to connect. No network coverage.” or “Message sending failed”, it means that the network connection has been lost, possibly because you are in a weak signal area, such as a tunnel or surrounded by buildings. Try moving to a different location and try again. Alternatively, you may be trying to access an option for which you have not subscribed with your service provider. Contact them for more information.
Why do the signal bars disappear on my Samsung SGH-I300 Cell Phone?
If the bars next to the signal strength indicator disappear on your Samsung Cell Phone, and you have just turned on your phone, wait about 2 minutes for it to find the network and receive a signal. If you are in a tunnel or elevator, move to an open place. This can also happen when moving between different service areas, which is normal.
Why does my Samsung SGH-I300 Cell Phone say 'Emergency call only'?
The SIM card may not be correctly installed. Check that the SIM card has been correctly installed.
What to do if my Samsung SGH-I300 malfunctions or does not function?
Remove the battery and then replace it. Turn on the phone. Or press the hole on the bottom of the phone to perform a soft reset.
What to do if I see 'Message sending failed' on my Samsung SGH-I300?
This can happen if the network connection has been lost. You may be in a weak signal area, such as in a tunnel or surrounded by buildings. Move to an area with better reception and try again. It may also be caused by trying to access an option for which you have not taken out a subscription with your service provider. Contact the service provider for further details.
Why is the LED on my Samsung Cell Phone travel charger blinking?
Try disconnecting the phone from the travel charger, remove the battery, and then replace it. Try charging again. If the problem persists, clean the metal contacts on the battery and the phone.
Why does the LED on my Samsung SGH-I300 travel charger turn yellow?
The travel charger is overheated. Disconnect the charger from the phone or unplug it from the power outlet. Wait until the charger cools down and then recharge the phone.
How to end a Bluetooth connection on my Samsung SGH-I300?
If another device is connected to your phone, you can either end the connection using the other device or by deactivating Bluetooth. Go to Bluetooth and select the setting Bluetooth ? Off.
Why I cannot connect to the remote Bluetooth stereo headset to my Samsung SGH-I300?
Ensure that the correct PIN was entered on the phone during the connection with the headset.
General| Brand | Samsung |
|---|---|
| Model | SGH-I300 |
| Category | Cell Phone |
| Language | English |
To Next Page
