Samsung SH09ZS2A - Setup and Configuration; Model Option Setup Method

Samsung Electronics16
5. Set Up the Model Option
5-1 Setting Option Setup Method
ex) Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously and
insert the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
2
3
4
5
6
1
2
The default value is .
Otherwise, push the button to .
Every time you push the button, the display panel reads or
repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
✳ Setting is not required if you must
a value which has a default.
3
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
4
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
5
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
6
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
DB98_16693A(2)_1 3/19/04 2:10 PM Page 16