Samsung SINGLE AC N Series - Fixing the Outdoor Unit in Place

359
Installation
※ In case you want more information about the controllers and accessories, please refer to the Controller and
Accessory TDB on pvi.Samsung.com site or Global Partner Portal site.
Fixing the outdoor unit in place
Install the outdoor unit on a rigid and stable base to
prevent disturbance from any noise caused by vibration.
When installing the unit at a height or in a location
exposed to strong winds, fix the unit securely to a
support (i.e., a wall or a ground).
Fix the outdoor unit with anchor bolts. Make sure that
the anchor bolts are 20 mm or higher from the base
surface.
(Unit : mm)
Anchor bolt hole
612
790
285
317
343
AC026/035RXADKG
Anchor bolt hole
(Unit : mm)
AC052/071RXADKG
(Unit : mm)
Anchor bolt hole
AC100/120/140RXAD*G
CAUTION
 Install a drain outlet at the lowest end around the
base for outdoor unit drainage
 When installing the outdoor unit on the roof,
waterproof the unit and check the ceiling strength.
 Make sure that the wall can support the weights of
the rack and the outdoor unit.
 Install the rack close to the column as much as
possible.
Optional: Fixing the outdoor unit to a wall with a rack
Soft rubber designed to cut off vibration from
rack to wall. (not supplied with product)
Designed to cut off residual vibration from
outdoor unit to rack. (not supplied with product)
Anchor bolt
Base surface
20 mm
 Install a proper grommet in order to reduce noise
and residual vibration transferred by the outdoor unit
towards the wall.
CAUTION
 When installing an air guide duct, be sure to check
the following:
- The screws do not damage the copper pipe.
- The air guide duct is fixed firmly on the guard fan.