Disassembly and Assembly
87
5G mmWave Antenna Remove
The 5G mmWave antenna is only supplied with United States devices.
1 Check the screws at the 2 different points on the left 5G mmWave antenna module
and remove them using a cross-head screwdriver.
When removing the screws, be careful not to damage the battery.
Check the number of screws that have been removed and store them carefully to
make sure that no unassembled screws are left inside the device during assembly.
2 Insert the pointed end of your tweezers in the gap between the lower screw mount of
the left 5G mmWave antenna bracket and the frame.
Pry up on the bracket until you can grab it with the tweezers or your fingers.
Be careful not to damage the battery.
Do not use a connector or cable to pull out the module.
To Next Page
Loading...
