Samsung SMC-210 - Parts and Post-Service Checks

2-2
Alignment and Adjustment
2-5-1 Adjustment Mode
Set the data as table using control key.
MAIN ADJUSTMENT PARAMETER
FUNCTION OSD RANGE ADJUST DATA REMARK
SUB BRIGHT SBT 0 ~ 13 STEP 7
SUB CONTRAST SCT 0 ~ 13 STEP 7
SUB COLOR SCR 0 ~ 23 STEP 11
S-CORRECTION SC 0 ~ 63 STEP 10
RED CUTOFF RG 0 ~ 63 STEP 31
GREEN CUTOFF GG 0 ~ 63 STEP 31
BULE CUTOFF BG 0 ~ 63 STEP 31
PAL VERTICAL SLOPE PSL 0 ~ 63 STEP 25
PAL VERTICAL SHIFT PVS 0 ~ 63 STEP 32
PAL VERTICAL AMP PVA 0 ~ 63 STEP 32
PAL HORIZONTAL SHIFT PHS 0 ~ 63 STEP 32
NTSC VERTICAL SLOPE NSL 0 ~ 63 STEP 25
NTSC VERTICAL SHIFT NVS 0 ~ 63 STEP 32
NTSSC VERTICAL AMP NVA 0 ~ 63 STEP 32
NTSC HORIZONTAL SHIFT NHS 0 ~ 63 STEP 32
It is possible to choose PSL, PVS, PVA, PVH when PAL signal inputted.
It is possible to choose NSL, NVS, NVA, NVH when NTSC signal inputted.
Note
2-5-2 Test Pattern (Aging Mode)
ΠThese test pattern are used in Service and Aging.
 RED
 GREEN
 BLUE
 WHITE
´ Choose White at Aging.
ˇ Choose R.G.B at Purity Adjustment.
2-5-3 Option Byte
ΠAdjust option byte as right Byte 0 : 00
Byte 1 : 00
2-5-4 Data Save and Exit
ΠPress Factory Mode Exit Key Twice to exit from factory mode.