Alignment and Adjustment
2-3
2-6 White Balance Adjustment
2-6-1 High-Light Adjustment
Œ Input Lion Head and White Pattern.
´ Aging over 30 minutes.
ˇ Check a data in factory mode.
¨ Cheak whether RG, GG and BG are 31 or not.
ˆ Adjust RG, BG to obtain X=290, Y=300.
2-6-2 Low-Light Adjustment
Œ It is not necessary to adjust Low-Light.
When High-Light is adjusted, Low-Light is simultaneously adjusted.
2-7 Geometry Adjustment (When NTSC Signal Inputted)
(SC NVL NVS NVA NHS)
Œ Input Lion Head Pattern.
´ Set SC data 10 or 11 at factory mode.
ˇ Adjust NSL to be round a lower side like a upper side.
¨ Adjust NVS until the display is located at vertical center.