Samsung SPH-A900 - Page 25

SAMSUNG Proprietary-Contents may change without notice
Test Procedure
6-5
This Document can not be used without Samsung's authorization
6-4 Test Procedure
6-4-1 CDMA/PCS mode
- Change the test mode
A.
To change the phone's state from Normal Mode to Test Mode, You should enter the following keys.
:Press[47*869#1235]
B.
The command "0 0 1" is Suspend.
C.
The command "0 2 2" is mode and channel change.
"20363"
Channel number
Mode:CDMA
"30600"
Channel number
Mode:PCS
and press enter key from the soft key board to save mode/channel value..
D.
The command "0 0 1" is Suspend.
E.
To finish the Test Mode, You should enter the command "0 0 2".
- Channel selection and Tx power output level control
CDMA
A.
EntertoTestMode[47*869#1235]
B.
"0 0 1" : Suspend.
C.
The command "0 2 2" is mode and channel change
"20363"
Channel number
Mode:CDMA
Push the [OK] key to save.