changingtheL0cati0,0rthe
Press the Menu button. Move the joystick up or
down tO select P P , the n press the joystick tO
enter.
Move the joystick up or down to select "Locate"
then move the joystick left or right to enter.
Move the joystick to move the PIP screen where you
want,
Press the Menu button to exit.
ChangingtheScreenSize
(WhenenteringtheVideomode)
When you press the Aspect button on the remote control, the PDP's screen mode should appear in
sequence. The screen displays in this order: Wide, Panorama, Zoom1, Zoom2, Stretch, 4:3.
• If you watch a still image or the 4:3 mode for a long time(over 2 hours), an image may be burned
onto the screen, view the monitor in wide or panorama mode as much as possible.
Wide
Sets the picture to 16:9 wide mode.
Zoom2
Magnifies the size of the picture more than
Zoom1.
Panorama
Converts regular 4:3 aspect ratio screen to
widescreen.
Stretch
Moves the Zoom2 picture up a little to fully
show the bottom. Use this picture size if you
want to view the Zoom2 picture along with
captions when watching movies.
Zoom1
Magnifies the size of the picture vertically on
screen.
Caption
4:3
Sets the picture to 4:3 normal mode. This is a
standard PDP screen size.
• In VIDEO, S-VIDEO and Component1(480i) modes, all screen modes can be selected.
(Wide _ Panorama _ Zoom1 Zoom2 Stretch 4:3).
32 33
To Next Page
Loading...
