Information PowerSaver,
Preset:
3resstrle RGB button to selectthe PCmode
Press the Menu button. Move the joystick up or
down [o select "SETUP" then press thejoyshck [o
enter.
Move theaoystick down to select "Miscella-
up
or
neous", then move thejoystick left or right to
enter.
Move the joystick up or down to select "lnforma-
tion", then move the joystick left or right to enter,
Press the Menu button to exit,
This monitor has a built-in power management system called Power Saver, This power management
system saves energy by switching your monitor into a low-power mode when it has not been used for a
certain amount of time, This power management system operates with a VESA DPMS compliant video
card installed in your computer. You use a software utility installed on your computer to set up this fea:
ture. See the table below for details.
' Normal Power-saving Function Mode
Suspend Mode Power-off Mode
State Operation Standby Mode Position A1 Position A2
Horizontal Sync Active Inactive Active Inactive
Vertical Syne Active Active Inactive Inactive
Video Active Blanked Blanked Blanked
Power Green Red Blinking Red Blinking ' Red Blinking
I
Indicator (1Sec Interval) (1 sec Interval) (1Sec Interval)
• Thism_nit_raut_matica__yreturnst_n_rma__perati_n_henh_riz_nta_andvertica_syncretur n.
• This occurs when moving the computer's mouse or pressing a key on the keyboard •
• For energy conservation, turn your monitor OFF when it isnot needed, or when leaving it unattend-
ed for long periods.
58 59
To Next Page
Loading...
