Samsung SR-65KTC - Load Status Display

－16－
NO
1
2
3
4
5
6
7
8
MODE DISPLAY
REFRIGERATOR SUBORDINATE
FREEZER SUBORDINATE
(LOAD STATUS DISPIAY TABLE)
1) Press power freezing / regular conditing and power refrigerating / power saving key for five seconds then
press temperature control key in the refrigerator after temperature display lamps on and off three times
2) This mode shows which lamps is being sourced signal from MICOM currently. This doesn’t mean the load is
operate due to the open wire or relay missing though the display shows the compressor operating.
3) Load status display return to normal mode after sixty seconds.
4) Follows are load status and related dispay.
6. LOAD STATUS DISPLAY
ITEM
COMP
F-FAN
FREEZER DEFROST HEATER
R-FAN, S-FAN
REFRIGERATOR DEFROST HEATER
INITIAL MODE
OVERLOAD
LOW TEMP MODE
DISPLAY LED
FREEZER ”LOW”
FREEZER ”LOW,MID”
FREEZER ”MID”
REFRIGERATOR ”LOW”
REFRIGERATOR ”MID”
POWER FREEZER
POWER REFRGERATOR
POWER SAVING
DISPLAY
RELEVANT LED ON DURING COMPRESSOR OPERATION
RELEVANT LED ON DURING F-FAN OPERATION
RELEVANT LED ON DURING FREEZER DEFROST HEATER ON.
RELEVANT LED ON DURING S-FAN AND F-FAN OPERATION
RELEVANT LED ON DURING REFRIGERATOR DEFROST
RELEVANT LED ON QITH INITIAL POWER INPUT.
RELEVANT LED ON QHEN ROOM-TEMP. IS OVER 35℃
RELEVANT LED ON QHEN ROOM-TEMP. IS BELOW 15℃