Samsung SR-S24FTA - 11-7) Disassembly of Ice Maker; 11-8) Assembly of Ice-Maker

1-7)
Disassembly
of
Ice
Maker
|
4.
Pull
out
the
bucket
from
the
freezer.
2.
Disassemble
the
SUPT-ICE
MAKER,
which
fixes
the
ice-maker,
and
the
wire
housing
in
the
rear
of
the
maker.
3.
Disassemble
by
lifting
the
SUPT-ICE
and
FIXER-CASE
in
the
front
of
the
maker
up
(©
direction)
and
pulling
the
ICE-MAKER
KIT
out
to
the
front
(@
direction).
(Do
not
disassemble
each
component
of
the
ICE-MAKER
KIT.
Otherwise,
the
setting
value
may
be
changed.)
11-8)
Assembly
of
Ice-Maker
,
)
1.
Fit
the
rear
rising
of
the
ICE-MAKER
KIT
to
the
front
slot
of
the
TRAY
ICE.
2.
Lift
FIXER-CASE
at
the
front
of
the
SUPT-ICE
MAKER
up.
(@
direction)
3.
Place
the
top
rising
of
the
ICE-MAKER
KIT
to
the
slot
of
SUPT-ICE
MAKER
for
insertion.
4.
Push
the
front
of
the
ICE-MAKER
KIT
while
maintaining
the
position.
(Be
careful.
if
you
overpush
the
ICE-MAKER
KIT,
the
fixed
rising
of
the
SUPT-ICE
MAKER
may
be
damaged.)
5,
When
the
front
of
the
(CE-MAKER
KIT
is
sagging,
it
means
the
assembly
is
not
right.
At
that
case,
perform
the
assembly
again.
-
REAR RISING
FRONT SLOT
FIXED RISING