18
1
2
3 4
Insert the stand neck into the stand base in the
direction shown in the figure.
Check that the stand neck is firmly connected. Tightly fasten the connecting screw at the bottom
of the stand base.
Place a soft cloth over the table to protect the product
and place the product onto the cloth so that the front
of the product is facing downwards.
Hold the back of the product as shown in the figure.
Push the assembled stand into the main body in the
direction of the arrow as shown in the figure.
5
Fasten the screws at the bottom of the stand neck. - Caution
Do not press down on the monitor. There is a risk of
damaging the monitor.
Installation
Attaching the Stand
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
―
The exterior may differ depending on the product.
To Next Page
Loading...
