Samsung SyncMaster 17GLi - Power Management System

3 Operating Instructions
Recall
pCi
Use
this
button
to
recall
factory
preset
settings. When you push the recall button,
the indicator LED changes color from
green to orange (the same as any other
function) and the OSD appears.
Hold down the recall button for several
seconds until the indicator LED’s color
changes to green, this indicates that the
factory settings for that timing have been
recalled. The OSD shows the progress of
the recall function.
Note: This operation resets all of the data
in the user memory area for the current
signal timing.
Degauss
e)
Magnetic fields can build up on the CRT
and cause color impurity. Use the degauss
button to demagnetize the CRT.
Push the button once to activate the
degaussing circuit. The degaussing circuit
automatically turns itself off after a few
seconds.
Warning: Don’t hold this button down for
longer than 3 seconds. If you do, it resets
all of the data in the user memory area. If
this occurs, you must remake your user
adjustments.
Gs)
Pinbalance & V-Linearity
To activate the vertical linearity and
pinbalance adjustment function, push and
hold in both the position and the size
buttons for longer than three seconds, or
until the power indicator LED changes
from orange to green and back to orange.
Use the right ( ® ) and left (<4) button to
correct the pinbalance distortion of one or
both sides.
Use the up ( A ) and down ( Y ) buttons to
correct the vertical linearity.
ri
3-6
Samsung Electronics SyncMaster 17GLi