Note
For more information on the driver installation and usage of the USB monitor, refer to Restrictions on
the 7”USB Monitor .
Installing and Using the USB Monitor
1. Engage and fix the USB monitor into the groove of the armrest holder.
2. You can adjust the location of the USB monitor.
Note
You can also adjust the length of the armrest holder after adjusting the location of the USB monitor.
1. Do not tilt the stand too far backwards when the USB auxiliary monitor is lifted up, as shown in
the figure. This may change the center of gravity of the product resulting in the product falling
causing product damage or personal injury.
2. When adjusting the angle of the USB auxiliary monitor stand, do not use too much force. This
may cause the stand to break.
Connections
To Next Page
Loading...
