If the installation fails
Note
If the installation is stopped because the New Hardware Wizard has failed, right-click ”My computer“,
and click “Properties” - “System Properties” - the ”Hardware“ tab. Click on the ”Device Manager“
and reinstall the driver by following these steps below.
1.
The symbol showing that the device has failed to be installed is displayed as shown in ( ,
)
2. In this case, click ”Scan for hardware changes” to run the Setup Wizard again. At this time, if the
installation fails, click (
, ) and right-click it. Select ”Driver Update” from the displayed
menu.
Checking the configuration
Note
After the installation, you can check the configuration by following these steps:
1. Right-click My computer, click Properties - System Properties - Hardware tab.
Using the Software
To Next Page
Loading...
