BNC mode is not supported if the component cable is connected. To use BNC mode, remove the
component cable and connect the BNC cable.
6. Component
Component mode is not supported if the BNC cable is connected. To use Component mode,
remove the BNC cable and connect the Component cable.
Note
• The direct button on the remote control is the 'SOURCE' button.
• For PC and DVI
, this is deactivated if the cable is disconnected.
Edit Name
MENU → ENTER → [Input] → → ENTER → [Edit Name] → , → ENTER
Name the input device connected to the input jacks to make your input source selection easier.
VCR / DVD / Cable STB / HD STB / Satellite STB / AV Receiver / DVD Receiver / Game /
Camcorder / DVD Combo / DHR / PC
Picture [PC / BNC / DVI Mode]
Available Modes
•
PC / BNC / DVI
•
AV
•
HDMI
•
Component
Note
• The TV menu is available when a TV tuner box is installed.
Adjusting the LCD Display
To Next Page
Loading...
