Samsung SyncMaster 400DX-2 - Connecting to a Camcorder; Connecting the BNC to BNC Cable

Connecting to a Camcorder
1. Locate the
AV output jacks on the camcorder. They are usually found on the side or back
of the camcorder. Connect a set of audio cables between the AUDIO OUTPUT jacks on
the camcorder and the AV/COMPONENT AUDIO IN [L-AUDIO-R] on the LCD Display .
2. Connect a video cable between the VIDEO OUTPUT jack on the camcorder and the AV
IN [VIDEO] on the LCD Display .
3. Select AV for the Camcorder connection using the Source button on the front of the LCD
Display or on the remote control.
4. Then, start the Camcorder with a tape inserted.
Note
The audio-video cables shown here are usually included with a Camcorder. (If not, check
your local electronics store.) If your camcorder is stereo, you need to connect a set of two
cables.
Connecting the BNC to BNC cable
1. Connect the
BNC/COMPONENT IN [R/Y, G/P
B
, B/P
R
] ports on the monitor to the BNC
port on the external device using the BNC to BNC cable.
Connections