Adjusting the Monitor
Direct Functions
Note
• The monitor LED displays for 10 seconds
• Press the MENU button four times continuously to exit OSD
AUTO
When no OSD is displayed,press” ” button to perform the AUTO function,the auto adjustment
screen appears as shown in the animated screen on the center.
Auto adjustment allows the monitor to self-adjust to the incoming Analog signal.
If auto adjustment does not work properly, press “ “ button again to adjust picture with
more accuracy.
If you change resolution in the control panel, auto function will be executed automatically.
Brightness
When no OSD is displayed,press”
” button to perform the Brightness function.
OSD Functions
Brightness
MagicBright Custom NotePC Internet Movie Dynamic
Contrast
Image Size Auto Wide
Language
Exit
Brightness
(Not available in MagicBright mode of Dynamic Contrast.)
You can use the on-screen menus to change the brightness according to personal prefer-
ence.
To Next Page
Loading...
