4-2. Alignments and Adjustments
4-2-1. General Alignment Instuction
Usually, a color LED/LCD TV needs only slight touch-up adjustment upon installation. Check the basic characteristics 1.
such as height, horizontal and vertical sync.
Use the specied test equipment or its equivalent.
2.
Correct impedance matching is essential.3.
Avoid overload. Excessive signal from a sweep generator might overload the front-end of the TV. When inserting signal 4.
markers, do not allow the marker generator to distort test result.
Connect the TV only to an AC power source with voltage and frequency as specied on the backcover nameplate.
5.
Do not attempt to connect or disconnect any wire while the TV is turned on. Make sure that the power cord is 6.
disconnected before replacing any parts.
To protect against shock hazard, use an isolation transformer.
7.
www.freeservicemanuals.info
Published in Heiloo, Holland.
To Next Page
Loading...
