Control
Factory Name Data Range Use
EDID
EDID ON/OFF OFF
Download EDID data to EEPROM.
Set "ON" of EDID ON/OFF
1.
Go EDID WRITE ALL and Push 2.
Enter or ► button.
If You See Success message,
3.
SET "OFF" of EDID ON/OFF
Case of HDMI 1.2 EDID Service
Go EDID VER and Set HDMI 1.2
1.
Go EDID PORT and Select HDMI 2.
port
EDID WRITE ALL …
EDID WRITE PC …
EDID WRITE HDMI …
EDID WRITE HDMI1 …
EDID WRITE HDMI2 …
EDID WRITE HDMI3 …
EDID WRITE HDMI4 …
EDID VER …
EDID PORT …
EDID WRITE DVI …
Sub Option
RS-232 Jack UART Debug/Logic/UART
Select Setting of UART port.
Initial value is "UART"
Watchdog ON ON/OFF
Select Watchdog.
Initial value is "ON"
WD Count 0 255
Watchdog Count.
Read Only.
Dimm Type EXT xed
Select Dimming Type.
Initial value is "EXT"
Lvds Format JEIDA JEIDA/VESA/19INCH
Select LVDS format.
MFM : "VESA"
OTN Server Type operating operating/development
OTN Test Server OFF OFF/ A/B/C/D/E Zone
OTN Support ON ON/OFF
OTN Reset not modifyed
OTN Duration OFF ON/OFF
OTN Fail Test OFF ON/OFF
View Log not modifyed
KEY SENSITIVITY 34 0~255
TA350 : 32
TA550 : 34
Hotel Option
Hotel Hospitality OFF
Shop Option
Shop Mode OFF ON/OFF
Exhibition Mode OFF ON/OFF
www.freeservicemanuals.info
Published in Heiloo, Holland.
To Next Page
Loading...
