Samsung U6A4 - Fuse-Busbar Assembly; Figure 3-30: Rack Fuse Busbar Assembly

3. Installing the Product
40 English 8/2020. Rev 0.3
3.10.4 Fuse-Busbar Assembly
Three types of fuse-busbar assemblies must be assembled before installing them to the Battery Modules.
NOTICE
 Rack Fuse Busbar Assembly is assembled at the installation location.
 M12 X 16L screws are used to assemble the busbars and fuse.
 The fastening torque should be 30 Nm (300 kgf/cm).
 After torqueing, torque mark the screws using a colored marker or a torque seal.
 When assembling the fuse, make sure the “red indicator arm” on the fuse is facing the front of
the unit.
1. Assemble the Rack fuse Bus-bar assembly.
Rack fuse bus-bar assembly is comprised of one “RACKFUSE BUSBAR_R_128S”, one “RACKFUSE BUSBAR_L_128S”, two
“SCREW M12 X 16”, one “FUSE COVER #1”, and one “FUSE”
Figure 3-30: Rack Fuse Busbar Assembly