No Video (Component)
*Refer to the next page to check the lacation such a CN201 or IC1001 SVC Manual mentioned.
Symptom Audio is normal but no picture is displayed on the screen.•
Major
checkpoints
Check the Component source.•
This may happen when the LVDS cable connecting the Main Board and the Panel is •
disconnected.
Diagnostics
Power indicator LED is off.
Lamp(Backlight) on, no video ?
No
Check a set in the ‘Stand-by mode’.
Yes
Check the component source and
check the connection of component
cables(Y,Pb,Pr) ?
No
Input the component source properly.
Yes
1
Does the component data appear at ?
Comp1 Y : R530
Pb : R531
Pr : R532
No
Check CN502 or Compnent gender.
Change the Main Board.
Yes
2
Check the LVDS clk signal at output of
Main board.(TX)
ODD_TXCLK- / ODD_TXCLK+
EVEN_TXCLK- / EVEN_TXCLK+
No
Check IC1001(X10+).
Change the Main Board.
Yes
Check the LVDS cable?
Replace the T-con / LCD panel?
No
Please, Contact Tech support.
Caution Make sure to disconnect the power before working on the Power board.
To Next Page
Loading...
