Samsung UN40J6300AF - Method of Color Calibration (AV); Method of Color Calibration (Component); Method of Color Calibration (PC); Method of Color Calibration (HDMI)

Method of Color
Calibration (AV)
Apply t
he NTS
C Latti
ce (N0
. 3) pat
tern s
ignal to
the
A
V IN 1
port.
1.
Press the Source key to switch to “AV1” mode.
2.
Enter Service mode.
3.
Select the “ADC” menu.
4.
Select the “AV Calibration” menu.
5.
In “AV Calibration Off” status, press the “► ” key to perform Calibration.
6.
When Calibration is complete, it returns to the high-level menu.
7.
You can see the change of the “AV Calibration” status from Failure to Success.
8.
Method of Color Calibration (Component)
Apply t
he 720p
Lattice
(N0. 6)
pattern
signal
to the C
ompone
nt IN 1
port.
1.
Press the Source key to switch to “Component1” mode.
2.
Enter Service mode.
3.
Select the “ADC” menu.
4.
Select the “Comp Calibration” menu.
5.
In “Comp Calibration Off” status, press the “ ►” key to perform Calibration.
6.
When Calibration is complete, it returns to the high-level menu.
7.
You can see the change of the “Comp Calibration” status from Failure to Success.
8.
Method of Color Calibration (PC)
Apply t
he VES
A X
GA
Lattice
(N0. 21
) patter
n signa
l to the
PC IN
port.
1.
Press the Source key to switch to “PC” mode.
2.
Enter Service mode.
3.
Select the “ADC” menu.
4.
Select the “PC Calibration” menu.
5.
In “PC Calibration Off” status, press the “ ►” key to perform Calibration.
6.
When Calibration is complete, it returns to the high-level menu.
7.
You can see the change of the “PC Calibration” status from Failure to Success.
8.
Method of Color Calibration (HDMI)
Apply t
he 720p
Lattice
(N0. 6)
pattern
signal
to the H
DMI1/
DVI IN
port.
1.
Press the Source key to switch to “HDMI1” mode.
2.
Enter Service mode.
3.
Select the “ADC” menu.
4.
Select the “HDMI Calibration” menu.
5.
In “HDMI Calibration Off” status, press the “►” key to perform Calibration.
6.
When Calibration is complete, it returns to the high-level menu.
7.
You can see the change of the “HDMI Calibration” status from Failure to Success.
8.
4-24
4. Troubleshooting