4-3-2. Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
If you do not have Factory remote control•
Power OFF MUTE 182 Power On
If you have Factory remote control•
INFO Factory
Some items are not available without a factory remote.•
Option
Control
Debug
SVC
ADC/WB
Advanced
T-HKMAKUC-XXXX.XX
T-HKMAKUS-XXXX
tztv-X.X.X-hawk-m-uhd_XXXXXXXX.X
Main SPI version : 0000XXXX
OCM SPI version : 0000XXXX
BT Version : BLUETOOTH-VER-00XX
E-MANUAL : HMUATSCJ-X.XXX
CAMERA VERSION : Not Support
BLASTER VERSION : Not Support
E-POP Version : HAWKMUD-XXXX.X
EDID SUCCESS
HDCP NOT SUPPORT
CALIB : AV/COMP/PC/HDMI/
OPTION : 55A1UU7WJ,US,7500,NONE
DTCP Not Support
FRC[HAWK-UFT] Panel[SDC-120Hz]
FW[62XX] Data[0303] LD[BAR-1X5][XX]
TCON[HawkUFT]Flash[J55A1W0F0]
Demura[XXXX]
Model : UNXXJU7500
Wired MAC ----
Wireless MAC ----
WIFI : 0000
CO Nf/ W/ M/ D/ HX P/ AO O S/ N/ RO SC/ Six/
Factory Data Ver : XXX / EERC Version : XX
CPLD/LD : N/A
SmartControl : ****
Date of purchase : --/--/----
Main SW Version
Sub Version (Main, Jak)
Bluetooth Version
E-Manual Version
FRC SW Version
Condition of Wired Mac
TCON Version
Condition of Wireless Mac
To Next Page
Loading...
