4-3. Factory Mode Adjustments
4-3-1 Entering Factory Mode
To enter ‘Service Mode’ Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
MUTE
Power OFF 1 8 2 Power On
4-3-2 How to Access Service Mode
Using the Customer Remote
Turn the power off and set to stand-by mode1.
Press the remote buttons in this order; MUTE-1-8-2-POWER ON to turn the set on.2.
The set turns on and enters service mode. This may take approximately 20 seconds.3.
Press the Power button to exit and store data in memory. 4.
- If you fail to enter service mode, repeat steps 1 and 2 above.
0Using the Factory Remote
Press the 'info'+'factory' key of your Factory Remote.1.
The set enters service mode right away.2.
Initial SERVICE MODE DISPLAY State
(If you entered Service Mode by Customer Remote , 'Expert' and 'Advanced' menu would be hidder for security)
Mode : CATV , RES : NOSIGNAL
Option
Control
SVC
Expert
ADC/WB
Advanced
T-VALAUSC-0044
T-VALAUSS-0722
EDID SUCCESS
CALIB : AV X COMP X PC O HDMI O
Option : 0000 1100 10
DTP-SP-VAL-1048
RFS:42-42
2009-12-25
FRCS FW : 0111, CONFIG : 6D00
N240:0006
READING : 2010
Type : NONE
Model : LNNOC750
MAC SUCCESS
Factory Data Ver : 189
EERC Version : 81
DTP-AP-COMP-340
DTP-HIIG-0335
DTP-BP-0343-01
Date of purchase : --/--/----
"Advanced" is hidden menu.
You can not enter "Advanced" mode even you entered Service Mode using Factory Remote.
Buttons operations withn Service Mode
Menu Full Menu Display/Move to Parent Menu
Direction Keys
/
Item Selection by Moving the Cursor
Direction Keys
/
Data Increase / Decrease for the Selected Item
Source
Cycles through the active input source that are connected to the unit
To Next Page
Loading...
