Samsung UN46C9000ZF - Page 99

4-7
4. Troubleshooting
Problem
Possible Solution
Although the TV is placed close to the AP
and the dongle is inserted into the TV, the
sharing device cannot be connected to using
auto-conguration.
Select [Menu] •  [Setup]  [Network] and check if SWL is Off.
If the AP is turned off, the TV will try to re-establish a connection for 2 minutes.
Although the TV is placed close to the AP
and the dongle is inserted into the TV, the
sharing device cannot be connected to using
auto-conguration and a message that it is
connecting is displayed only.
Check if the AP is not turned off during connection. •
If the AP is turned off, the TV will try to re-establish a connection for 2 minutes.
In order to use the Samsung Auto
Conguration function, I did as the user
manual instructed. I get a message that
connecting to an external network has failed.
The Samsung Auto Conguration feature is designed to establish an auto •
connection between the TV and the gateway of the AP. It performs a connection
test if the AP is connected to an external network.
If the AP is not connected to an external network, a message that establishing a
connection to an external network has failed is displayed. In this case, connect the
AP to an external network. After a connection to the external network is established
through a network test, you can use the network without any problem.
Check if the AP is connected to an external network.
If you perform a test when a connection to an external network is established
through a LAN cable, you will obtain successful test results.
When SWL is On, I cannot connect to the
5GHz Wi-Fi mobile device.
SWL is connected to a Wi-Fi mobile device which uses 2.4GHz bandwidth and •
supports PBC (Push Button Conguration) mode.
A mobile device which uses 5GHz or 2.4GHz bandwidth but does not support PBC
cannot be connected to the TV.
* WPS: WPS is the acronym for Wi-Fi Protected Setup, and includes two types:
PBC (Push Button Conguration) type which performs cross certication with the
press of a button and PIN type which performs cross certication when a PIN
(Personal Identication Number) code is entered.
Although the TV is placed close to the AP
and the dongle is inserted into the TV, the
sharing device cannot be connected to using
auto-conguration and a message that it is
connecting is displayed only.
If Samsung Wireless Link is On, a 5G-bandwidth wireless sharing device may not •
be found in a search (restriction).
If Samsung Wireless Link is Off or the product does not have the Samsung •
Wireless Link function, please retry searching to nd the sharing device. (May not
be found in a search depending on the settings of the wireless connection.)
In a network test over a wireless connection,
the second items which include the IP
address, subnet, gateway and DNS server
fail.
If the IP address, subnet mask and gateway were typed in manually, check that •
valid values were entered. (For example, 0.0.0.0 is not valid for an IP address,
subnet mask or gateway address.)
If the IP address the user entered in is invalid, change it to a valid IP address.•
In a network test over a wireless connection,
the third item, gateway ping fails.
If the IP address is automatic and connected to a sharing device, check the 1.
settings of the sharing device (AP) that is using a cable connection, or consult the
corresponding Internet service provider.
If the IP address is manual, check that the IP address is entered in correctly. 2.
(Here, the user should conrm if the manual IP entered in is valid.)
In a network test over a wireless connection,
the fourth item, Internet service test fails.
Please consult the corresponding Internet service provider (an Internet network •
service provider the user has subscribed to such as KT).