LAN Connection for Static IP Environment
The procedures to set up the network using a static IP address are described below. You have to manually enter the IP address,
subnet mask, gateway, and DNSthat are provided by your Internet Service Provider (ISP).
1. Connect the LAN port on the rear panel of the TV and the LAN port on the wall using the LAN cable.
The LAN Port on the Wall TVRear PaneE
O LAN Cable
You can connect the LAN via a Sharer (Router).
The LAN Port on the Wall TVRear Panel
IP Sharer
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
Ifyou are using a static IP address, your ISP will inform you of the IP address, subnet mask, gateway, and DNS. You must
enter these values to complete the network settings. If you do not know the values, ask your network administrator.
For the information on how to configure and connect a Sharer (Router), refer to the owner's manual for the corresponding
product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router).
Ifyou use an IP Sharer (IP Router) that supports DHCP, you can set up the device as either DHCP or static IE
For the procedures to use a static IP address, ask your Internet Service Provider.
To Next Page
Loading...
