BACKLIGHTS
Activate Backlights Test1. :
Disconnect Lead Cable from Main Board to Power Supply. -
TV Screen for active backlight LEDs. √
If NO BACKLIGHTS2.
Minus (Control) & Plus pins (Supply) on the Panel Connector voltages to the Panel. √
If no pin voltages replace SMPS. -
If BACKLIGHTS ON BUT PANEL SECTION(S) OFF3.
The Supply Drive √ + pins. All should measure same.
If a - + pin measures higher voltage, a string(s) of LEDs are likely open.
Remove Panel connector and verify same open backlight voltage condition. - Replace Panel.
If a 4. + pin measures low voltage disconnect connector to panel
The Low Plus Pin Voltage again. √
If it stays low the - SMPS is defective, if it goes high, defective Panel.
For BACKLIGHT DIMMING PROBLEMS:
Go to • Menu £ Picture £ Backlight and vary level (0 – 20)
If no backlight changes observed:•
Panel Connector minus (-) pin voltages and P-DIM voltages (CNL801) while changing backlight level. √
If minus Panel voltages don’t change, and P-DIM changes, replace • SMPS.
If P-DIM doesn’t change replace • Main/T-CON Board.
MUTE 4 1 9 EXIT to test Panel Backlight Sections.
To Next Page
Loading...
