3-2
3. Disassembly and Reassemble
Description & Screws Picture Description
3
Use Open Jig to release tape in corners and
all clips as indicated in red on sides and top &
bottom.
Gently lift up the Rear Cover starting at the top
being careful of function assembly at the bottom.
When the 4 points (•
)Hook is broken.
Although the hook is broken, the appearance
of the Rear cover is no problem and Gap
problem is not appeard after re-assembly.
To prevent the Inner Hook's broken.•
1. Catch the upper section of the rear cover.
2. Open the rear cover from top to bottom.
If the wire is bent, need to change the wire.•
Jig Direction
Jig Direction
Jig Direction
Bottom : 4 point Locking
Top : 10 point Locking
L : 6 point Locking
R : 6 point Locking
Center : 1 Point Locking
Panel Back Side View•
55 inches -
65 inches -
To Next Page
Loading...
