04 Initial Setup
When you turn on your TV for the first time, it immediately starts the Initial Setup. Follow the instructions
displayed on the screen and configure the TV's basic settings to suit your viewing environment.
• Noise may occur temporarily when the TV communicates with mobile devices.
• The SmartThings app is available on mobile devices for Android 6.0 or higher and iOS 10 or higher.
• To perform initialization by using the SmartThings app, the mobile device must have been connected via
Wi-Fi.
• When the pop-up for setup does not appear automatically on the SmartThings app of your mobile
device, proceed with the process after manually adding the TV using Add Device on the dashboard of the
SmartThings app.
Using the TV Controller
You can turn on the TV with the TV Controller button at the bottom of the TV, and then use the Control menu.
The Control menu appears when the TV Controller is pressed while the TV is On. For more information about its
usage, refer to the figure below.
• The screen may dim if the protective film on the SAMSUNG logo or the bottom of the TV is not detached.
Please remove the protective film.
TV Controller / Remote control sensor
Press: Move
Press & Hold: Select
The TV Controller is located on the bottom of the TV.
Control menu
: Power Off : Volume Up
: Channel Up : Volume Down
: Channel Down : Source
English - 13
To Next Page
Loading...
