In case touching this KEY after the HOLD during the spin cycle, it will perform the ADD function as
same with the p rocedure
since i t h as already entered the spin cycle.
If some other keys (water level or course key) are pressed during the spin-only functioned cycle, it
will make only a sound of pressing a key.
If the COURSE key is pressed after the HOLD during the spin-only cycle, it will perform to cancel
the M ANUAL function and to convert to AUTOMATIC COURSE function.
Resetofthespintimeattheprocedure
will discard the passed time of spin, and newly
perform spin for the time reset finally.
During the operation or after the HOLD, input of this key is only possible until the time before entering the
spin.
The display for selection at the initial stage of spin is as follows.
SPIN
:ON/OFFfor1sec
Only the actual time of spin will be displayed on the 8 SEGMENTs.
-->
5MIN
at early time
The display for input of START key is as follows(3 seconds after).
SPIN
:ON/OFFfor1sec
The remaining time will be displayed on the 8 SEGMENTs.
-->
10MIN
at early time
(4) Selection of WASH-ONLY function (for washing at each course)
If this key is pressed before pressing START key at the initial stage, it will select the WASH-ONLY
function. Input of START key at this time will perform the WASH-ONLY function, and every touch of
this key before or after the START will change the display as follows.
20MIN
→
22MIN
→
24 MIN
→
26 MIN
→
30 MIN
→
26 MIN
→
8MIN
→
10 MIN
→
12 MIN
→
14 MIN
→
16 MIN
→
18 MIN
(standard)
5MIN
→
7MIN
→
9MIN
→
11 MIN
→
13 MIN
→
15 MIN
→
1MIN
→
3 MIN (saving low water level)
IftheSELECTCOURSEkeyispressedaftertheHOLDduringtheWASH-ONLYfunctioncycle,itwill
cancel the function of MANUAL s election and convert to the AUTOMATIC function.
Reset of the washing time at the procedure
will discard the passed time of washing, and newly perform
washingforthetimeresetfinally.
During the operation or after the HOLD, input of this key is only possible until the time before entering the
DRAIN cycle.
The display during the washing cycle is as follows.
ì WASHî : ON/OFF for 1 sec
The remaining time will be displayed on the 8SEGMENTs.
-->
20 MINî at early time
The display during the washing cycle is as follows (3 seconds after).
ì WASHî : ON/OFF for 1 sec
The remaining time will be displayed on the 8SEGMENTs.
-->
25MINî at early time (based on HIGH WATER LEVEL)
To Next Page
Loading...