Samsung Wall Mounted Type Series - Remote Control Issues; Operational Temperature and Humidity Ranges

18_ appendix
PROBLEM SOLUTION
Remote control is
not working.
•Check if your batteries are depleted.
•Make sure batteries are correctly installed.
•Make sure nothing is blocking your remote control
sensor.
•Check that there are strong lighting apparatus near
the air conditioner. Strong light which comes from
fluorescent bulbs or neon signs may interrupt the
electric waves.
If the outdoor temperature is too low when heat mode is operating, special
operation will operate and it may make strange sound.It is normal operation
for the product safety.
OPERATION RANGES
The table below indicates the temperature and humidity ranges the air conditioner can be operated within.
Refer to the table for efficient use.
MODE
OPERATIONALTEMPERATURE
INDOORHUMIDITY IFOUTOFCONDITIONS
INDOOR OUTDOOR
COOLING
60˚F to 90˚F
(16˚C to 32˚C)
23˚F to 118˚F
(-5˚C to 48˚C)
80% or less
Condensation may occur on
the indoor unit with risk to have
either water blow off or drops on
the floor.
HEATING
81˚F (27˚C)
or less
-4˚F to 75˚F
(-20˚C to 24˚C)
-
Internal protection triggers and
the air conditioner will stop.
DRYING
60˚F to 90˚F
(16˚C to 32˚C)
23˚F to 118˚F
(-5˚C to 48˚C)
-
Condensation may occur on
the indoor unit with risk to have
either water blow off or drops on
the floor.
The standardized temperature for heating is 45˚F(7˚C). If the outdoor temperature drops to 32˚F(0˚C) or
below, the heating capacity can be reduced depending on the temperature condition.
If the cooling operation is used at over 90˚F(32˚C)(indoor temperature), it does not cool at its full
capacity.
appendix