English 23
Installation
C
3. Holde the adaptor and turn part (C) in
the arrow direction to loosen it by 5 mm
(*).
4. Insert the adaptor into the water tap,
and tighten the screws while lifting up
the adaptor.
5. Turn part (C) in the arrow direction to
tighten it.
E
6. While holding down part (E), connect the
water hose to the adaptor. Then, release
part (E). The hose ts into the adaptor
with a clicking sound.
7. If you are using a screw type of water
tap, use the provided screw-type
adaptor to connect to the water tap as
shown.
WD90N644OOW_03924L-00_EN.indd 23 2018/3/1 11:26:35
To Next Page
Loading...
